U-shaped red backlight for three-edge contour inspection
LXV-BRM324220-R uses an optimised bottom LED array and special light-guide plate to form a uniform U-shaped backlight. The open side gives the fixture access needed to silhouette three edges of a part while keeping the documented 324 × 220 × 35 mm panel around the target.
- Model
- LXV-BRM324220-R
- Single documented configuration
- Structure
- U-shaped flat panel
- One open side
- Boundary
- 324 × 220 × 35 mm
- Model-specific envelope
- Supply
- 24 V
- 10.1 W
Three-edge contour inspection
Place the part against the illuminated U so three outer edges appear as a high-contrast silhouette.
Open-side loading
Use the missing fourth side where a conveyor, nest, cable or protruding feature must enter the inspection area.
Profile measurement
Calibrate the camera against the illuminated plane before measuring edge position or part width.
Irregular-part access
Orient the opening toward the feature that cannot be enclosed by a conventional four-sided backlight.
How the optical structure solves the inspection problem
Review the product-specific optical behavior, confirmed values and technical graphics together before selecting the final configuration.
- Bottom LED array
- The emitters are distributed below the panel instead of appearing as direct point sources in the camera view.
- Special light-guide plate
- The guide plate redistributes the LED output into a more uniform transmitted field.
- U-shaped geometry
- Three illuminated sides surround the inspection region while one side remains open for access.
- Contour emphasis
- The bright field turns opaque part boundaries into dark silhouettes suitable for edge detection.
- Red output
- The documented R configuration should be checked against the camera response and target transmission.
Select from the actual optical, mechanical and electrical requirement
Do not select a custom light from appearance alone. Confirm target, contrast, field, interfaces and load together.
- 1
Map the three measured edges
Define exactly which part boundaries require transmitted contrast.
- 2
Confirm open-side access
Choose the U orientation around conveyors, nests and protrusions.
- 3
Fit the panel envelope
Reserve the complete 324 × 220 mm plan and 35 mm thickness.
- 4
Validate red contrast
Check camera sensitivity, target transmission and edge threshold under the red output.
- 5
Approve the final geometry
Confirm uniformity, field coverage and measurement repeatability on production samples.
Read the product model pattern
LXV-BRM324220-R- LXV
- Product prefix
- BRM
- U-shaped backlight family
- 324220
- Documented panel size code
- R
- Red output
LXV-BRM324220-R model range
Values remain attached to their own model and are not transferred between designs.
| Model | Output | Structure | Boundary | Voltage | Power |
|---|---|---|---|---|---|
| LXV-BRM324220-R | Red | U-shaped backlight | L324 × W220 × H35 mm | 24 V | 10.1 W |
Release the exact product drawing with the complete inspection station
Dimensions, openings, mounting, channels and thermal clearances belong to the selected product only.
- 01
Reserve the complete 324 × 220 × 35 mm body and keep all three illuminated sides unobstructed.
- 02
Orient the open side toward the loading path or feature that must remain accessible.
- 03
Place the target close enough to the emitting plane to control edge blur while preserving required mechanical clearance.
- 04
Use mounting-hole, cable and connector coordinates only from the exact LXV-BRM324220-R drawing; no independent detail drawing is present in the PDF.
- 05
Provide 24 V / 10.1 W capacity and verify controller, cable and connector ratings.
- 06
Calibrate edge thresholds and measurement scale, then validate uniformity and temperature at production duty.
